WeatherTech AlloyCover Installation Instructions And Owner's Manual - Step 2: Installing Cover
4
STEP 2: INSTALLING COVER
D. Unfold rear panel towards tailgate.
Hooks on rear panel will
automatically engage rear catch
on each side rail. Latches will
automatically engage each side
rail at rear of box.
NOTE:
Make sure all latches fully
engage the side rails when
closing cover.
C. Unhook storage clips at front of
cover and unfold middle panel
towards tailgate. Hooks on middle
panel will automatically engage
middle catch on each side.
A. Lift folded cover above rails and place
leading edge of front panel on rails at
front of box. Hold rear edge of folded
cover 1" above rails and slide cover
hooks underneath front catch on
each side.
B. With cover hooks engaged underneath
front catches, lower cover and engage
latch in retainment bracket on
each side.
NOTE:
Retainment brackets may be
loosened, adjusted and retightened
with a 7/16" wrench as needed.
Front catch
both sides
Front cover hook
both sides
Latch
both sides
Unhook storage
clips both sides
Latches will engage side
rails at rear of box
Retainment
bracket
both sides