Webasto 300101 Installation & Operation Manual - page 12
Installation / Operation Manual
Seat Comfort
12
15
Insulate the lateral "bridges", which protrude out from the previously
cut area, with the supplied black insulation tape. Assure proper
insulation.
16
Position the heating pads on the foam seat pad. Assure that the
insulated segments of the seat heater pads align with the grooves in
the foam cushion. The heating pad must not overlay the side seems.
17
After the seat heater pad is properly adjusted to the vehicle seat (foam
pad) make the final length determination.
Make sure that the length difference between the seat pad and back
pad does not exceed 75 mm. This ensures that there is no uneven
temperature distribution between both pads.
The seat heater pad should reach the forward edge of the seat
cushion. Cut accordingly and affix with double sided adhesive tape.
18
To assure proper fit and reduced interference with the seat foam, cut
out (use sharp knife) a square segment in the foam of the seat in the
area of the thermo protector.
After the heating pad is positioned, affix it with the adhesive strips in
the pad area where the wire harness is routed.