Webasto 300101 Installation & Operation Manual - Package Contents
Installation / Operation Manual
Seat Comfort
5
Notice To Users Of Carbotex Seat Heating Systems:
The seat heater is designed to control the temperature of the lower and upper seat segment of the front seats.
Proper temperature control of the vehicle seat increases the driver‘s comfort and enhances your basic health. The
seat heater operates in two power levels and can only be engaged with the ignition turned on. The switch label
“HI“ denotes the function best used to power up the seat heater in cold ambient temperatures. After the
system is running for a while the seat heater should be switched to the “LO“ position for maximum comfort. This
keeps the system from generating too much heat when running continuously.
The seat heater is equipped with safety device which senses and prohibits overheat conditions. If the seat heater is
operated for extended times in the HI position, it may be possible for the thermo probe to shut the heater down. In
such event it may take a few minutes until the system will re-engage again without action needed from the driver
(provided the switch is still in the on position). A 10 Amp fuse protects against electrical shorts and other
malfunctions. This fuse is located behind the seat heater switch. To check or replace the fuse, lift the switch out of
the case and expose the fuse socket for review.
Safety Advice:
• Do not place any heavy, sharp or pointed objects on the seats
• Any fluid spilled on the seats may destroy the seat heater and may cause damage to the
• vehicle. Never operate the seat heater while the seats are wet or soaked with fluid.
• Do not keep insulating material (sheets, covers, coats) on the seats while the seat
• heater is running. Do not place heat sensitive objects on the seats while the seat heater is running.
• To protect damage and discharge of the battery, avoid seat heater operation for extensive time periods
without a running engine.
• Individuals, extra sensitive to heat, should only operate the seat heater in the “LO“ position.
Package Contents
Components list / supplied with the “Carbotex-Universal-Seat-Heater-System“ kit:
Qty. Component / Part
1
Carbotex-Heating Element (pads) with automatic thermo protector (Dual pads kits are also available)
1
Wire harness with integrated fuse socket (incl.10Amp-fuse)
1
Seat heater switch
2
Installation tape (black - 300 mm)
4
Double stick adhesive tape (yellow - 280 mm)
1
Installation template (switch location, self adhesive)
1
Installation instructions
1
Owners manual (directions for operation, use & care)