Webasto 300101 Installation & Operation Manual - page 13
Installation / Operation Manual
Seat Comfort
19
For safety reasons you should protect those danger spots with suitable
material (i.e. insulation tape or shrinkable hose)
Careful not to damage seat heater when reinstalling upholstery
clamps.
Run the harness from the seat heater pads in a way that it exits the
seat to prevent harness exposure.
Use same procedures when running wires and harnesses (seat heater
pad upper back rest segment) from the back rest of the seat.
20
Installation of the vehicle seat / Function check
Re-assemble seat(s), accessories, and re-install seat(s) in the vehicle per
manufacturer’s service procedures.
Connect the wires from the two seat heating elements (lower pad and
back rest) to the wire harness that rests under the vehicle seat
assembly. It does not matter which wire connects to which side (both
elements receive same power).
Ensure proper fit and connection between plugs and receptors. Attach
the connectors and the harness to the seat frame to avoid interference
with moving parts. Assure seat function (without obstruction)
Reconnect the battery and check the function of the seat heater
system and re-check all other systems where components were
removed during the installation process.
A harness integrated fuse housing is located directly behind the seat
heater switch. Check that the 10 Amp flat fuse is in place and in
working order.
Assure that the owner receives proper information and instructions
about the operation, care and trouble shooting of their new seat
heater system. Make sure the owner knows the location of the 10
Amp fuse in case that a replacement is required. Hand out the owners
manual and instructions for the Carbotex seat heater
system.
13