Webasto CARBONTECH Installation Instructions And Owner's Manual - page 6
Page 6 of 20
11. Reposition heating pad onto cushion foam. Make sure thermostat is in the correct location.
(see step 9) Using the supplied gold double sided tape, attach the back edge of the heating pad
to the cushion foam. With the pad attached at the rear, determine the final length.
Note: Make sure that the length difference between the cushion pad and back rest pad is not
more than 275 mm (10-3/4 in).
See Fig 7
12. Trim if needed and attach using the supplied gold double sided tape
.
Note: Seat heater pad should reach the forward edge of the seat cushion.
See Fig 8
13. Route the heating pad wire harness so that it exits the trim cover in an inconspicuous area.
14. Installation is now complete. Double check to make sure the pad does not have any
wrinkles or is folded over onto itself. Once checked, carefully re-attach trim cover.
Back Rest:
1. Follow the same order and procedures for steps 5-13 for installing the heating pad to the
back rest.
Note: For step 11, use 2 pieces of gold double sided tape. One at the top and the other
approximately half way down to ensure the pad will not loosen and wrinkle over
time due to effects of gravity.
Fig 7
Fig 8