Telestart t80 t80_a_ba.Book seite 1 donnerstag, 22. April 2004 4:01 16.
Webasto_ba_ 1533.Book seite 4 freitag, 3. September 2004 11:00 11.
Deutsch 1 english 11 français 21 italiano 31 español 41 nederlands 51 d gb f i es nl dansk 61 svenska 71 norsk 81 suomi 91 polski 101 Русский 111 dk s n fin pl ru t80_a_ba.Book seite 2 donnerstag, 22. April 2004 4:01 16.
11 d gb operating and servicing instructions t80 advanced general information dear webasto customer ! We assume that the workshop / service center that carried out the installion ex- plained to you the operation and principle of functioning of your telestart t80 to your complete satisfaction. With t...
12 gb use the wireless webasto telestart t80 can be used to switch the webasto ther- mo top, thermo top t, thermo top z/c and thermo top e heaters or the ve- hicle's blower on and off at a distance of up to 600 m. The telestart indicates whether the signal has been received. To switch on the vehicle...
13 d gb programming telestart transmitter 1. Place batteries into the battery compartment of the transmitter. 2. Remove fuse 1a (black) from the heater's fuse holder (voltage interruption). 3. Wait at least 5 seconds. 4. Replace fuse in heater's fuse holder and within 5 seconds press the off button ...
14 gb checking the mode simultaneously depress and hold down the on and off buttons. Led illuminates: in red: heating mode in green: ventilating mode led extinguishes: – when the buttons are released, or – after 10 seconds mode setting depress the on and off buttons simultaneously twice within one s...
15 d gb response at the transmitter when the heater is switched on and off to switch on the heater or ventilation system hold the transmitter with the aerial upright and press the on button until the led lights up (approx. 1 second). The telestart in the vehicle will send a response. The led on the ...
16 gb note: in the 'heating' mode, the vehicle's heating system is to be set to "warm" prior to leaving the vehicle. In the 'heating' and 'ventilation' modes, the vehicle's fan switch is to be turned to position 1 in the case of 3-speed blower fans, and to position 2 in the case of 4-speed blowers. ...
17 d gb switching on/off using the pushbutton switch the parking heater or parking ventilation mode is indicated by a light in the pushbutton. Note: when the pushbutton switch is used for activating the heater, the operating mode (parking heating or parking ventilation) and operating duration most r...
18 gb checking and setting the operating time the operating time of the heater or the vehicle's fan can be preset on the trans- mitter in increments of 10 minutes. The operating time is factory-set at 30 min- utes. Note: in the case of thermo top and thermo top t heaters, an operating time of 20 or ...
19 d gb checking the operating time simultaneously actuate the on and off buttons within one second three times in rapid succession. Note: the first coded flashing signal that is emitted immediately upon the third actuation of both buttons has to be includ- ed into the count. The led flashes in acco...
20 gb returning to the default setting press the on and off buttons simultaneously for approx. 10 seconds until the led extinguishes. Default setting: heating mode, 30 minutes. Checking the batteries press the on or off button. Batteries led action almost spent flashes orange for 5 seconds replace b...
