Webasto Thermo Call TC2 COMFORT Installation Manual - page 11
Thermo Call TC2
15
Programming
Thermo Call TC2 can be programmed via
mobile or fixed network telephones that
feature tone dialing (DTMF).
- Call Thermo Call TC2 with a fixed
network or mobile telephone
- After the prompt for password entry,
enter the following technician
password:
- Then the following settings are
possible:
Setting system to push-button switch as the
operating element (=factory setting)
Setting system to digital timer or Telestart
T91 / T100HTM as the operating element.
Confirming serial number of the installed
Thermo Call TC2
Deactivate W-BUS connection
(= factory setting).
Activate W-BUS connection.
Restore factory settings of the Thermo Call
TC2
- Customer password
- Last activation
additional heater
- Operating period
30 minutes
- Operating element
Setting to push-button switch
- W-BUS connection
deactivated
Programming the System
Time
After programming via the technician
menu, the system time must still be set via
the customer menu. You can find the
corresponding information in the Thermo
Call TC2 operating manual.
NOTE:
If the main module is disconnected from the
vehicle power, all settings remain saved,
except for the system time.