Webasto Thermo Call TC2 COMFORT Installation Manual - page 6
Thermo Call TC2
10
Installation
Before starting the installation, insert the
SIM card (included in the delivery), into the
SIM holder after removing the holder from
the main module by pressing the yellow
button.The Sim card to be used must be
PIN free, the mailbox and the call
redirection functions must be
disabled.Replace the SIM holder into the
main module until it snaps into place.
Important!
Never remove or insert the SIM holder
into the main module whilst the module
power is on! This can result in damage
to the device and/or the SIM card!
Installation of Thermo Call
TC2
Caution:
The main module must be installed inside
the vehicle.
- Define the installation location of the
TC2 in the interior of the vehicle
(preferably near the digital timer in the
case of retrofits)
- Fasten Thermo Call with the sheet
metal screws (ensure sufficient space
for connection of the antenna and the
main cable harness)
Installation of GSM-
Antenna
The antenna must be fastened to the front
or rear window.However, never in the tinted
area or under the heating wires of the
window heating.
- Clean the windshield with the
cleaning cloth
- Peel off protective film from antenna
and fix antenna into place
- Run the antenna cable to the main
module (never shorten or kink!) and
screw to the main module.