Weber Vieluxe Slide-In Dual Burner Station Installation Manual - Countertop Burner
7
COUNTERTOP BURNER
STATION INSTALLATION
Gas Line
Burner Station
Frame
Burner
Station
Frame
"Island" Structure
Countertop
CAUTION: Use two people to lift and install the
Vieluxe
®
Countertop burner station.
1) Lift the burner station out of the packaging.
2) Push the burner station into the “island” structure
making sure that the grill frame rests on the top of
“island” structure.
3) Guide the gas line through he access hole in the
Burner Station frame while installing the burner station.
4) Lower the burner station down so it fits into the
“island” structure.
5) Lower until the top of the burner station frame is
resting on the “island” countertop.
Note: The burner station should be level, with the burner
station frame setting on the “island” countertop or
top surface.
Silicon
Sealant
6) Once the burner station is level with the top of the
“island” structure, apply a bead of silcon sealant
around the perimeter and front sides of the burner
station that is in contact with the “island” structure. This
will prevent moisture seepage. The sealant you use
must have a temperature rating above 120° F.
7) Attach the Countertop Burner Station to the "island"
structure by driving screws into the "island" structure
frame. Place the screws in slots located under both
sides of the burner station control panel.