WeBoost EQO User Manual - ______
CELL PHONE SIGNAL BOOSTER
3
______
Step 2:
Place Booster In
Strong Signal Location
IMPORTANT:
This is the most critical step of the installation process because it will
determine the overall performance of the Booster system. You must determine the
location of the best available cellular signal to maximize performance from your
Booster.
Do not power up Booster until STEP 4.
Having an accurate measurement of signal strength in decibels (dBm) is crucial
when installing your system. Decibels accurately measure the signal strength you
are receiving.
SIGNAL STRENGTH
EXCELLENT
GOOD
FAIR
POOR
DEAD ZONE
3G/1x
(typically voice)
-70dBm
-71 to -85dBm
-86 to -100dBm
-101 to -109dBm
-110dBm
4G/LTE
(typically data)
-90dBm
-91 to -105dBm
-106 to -110dBm
-111 to -119dBm
-120dBm
Turn off your cell phone’s WiFi to ensure you are checking
the cellular connection.
The dBm reading will be refreshed
every 30-60 seconds.
Want faster results? Once you have a reading, turn on
airplane mode.
Wait 15 seconds. Turn off airplane mode. The
signal strength reading is refreshed.
Walk around your home/office taking signal strength
readings until you find the area that has the best reception.
Place your Booster in the area with the strongest cell
phone signal. The LED light should be facing into the room.
-95
dBm
-90 dBm
-100 dBm
*May Need External Antenna
*If you receive POOR or a DEAD ZONE signal you may need an external antenna.
Contact Customer Support to receive FREE external antenna.
Booster
Antenna