9
12. Route the High Cable (50) over a 90mm Pulley
(34) and down through the Top Frame (4). Attach
the Pulley and a Cable Trap (36) to the bracket
on the Top Frame with an M10 x 50mm Bolt (53)
and an M10 Nylon Locknut (68).
Make sure the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley.
13. Route the High Cable (50) under a 90mm Pulley
(34). Attach the Pulley and a pair of Pulley
Covers (35) to the second set of holes from the
top of the two Pulley Plates (44) with an M10 x
52mm Bolt (52) and an M10 Nylon Locknut (68).
Make sure the small tabs on the Pulley Covers
are on top.
10. Insert the post on the Left Arm (7) through the
hole in the Press Frame (5).
Be sure the Arm is
behind the indicated bracket on the Press
Frame.
Slide a 25mm Washer (29) over the post on the
Left Arm (7). Attach an M6 x 43mm Bolt (61) to
the post with an M6 Nylon Locknut (72).
Be sure
the Locknut and the head of the Bolt are over
the edge of the Washer, as shown in the inset
drawing.
Press a 25mm Round Outer Cap (27) onto the
top of the post on the Left Arm (7).
Repeat this step with the Right Arm (6).
11.
Refer to the CABLE DIAGRAM on page 17 for
proper cable routing.
Locate the High Cable (50). Route the threaded
shaft end of the Cable up through the Top Frame
(4) and over a 90mm Pulley (34). Attach the
Pulley inside the Top Frame with an M10 x 65mm
Bolt (55), two M10 Washers (70), two M10 x
12.5mm Spacers (37), and an M10 Nylon Locknut
(68).
27
29
72
7
6
5
10
61
36
53
50
34
68
4
50
34
37
37
70
70
68
55
4
11
68
44
44
35
35
34
50
12
13
52
CABLE ASSEMBLY
29
61
72
Post
Slot
Bracket
Slot