Weider Pro 9635 User Manual - Assembly
5
ASSEMBLY
1
8
8
11
1
4
3
3
1
5
1.
Before beginning assembly, make sure
that you have read and understand the
information in the box above.
Locate and open the parts packet labeled
“FRAME ASSEMBLY.”
Insert six M8 x 62mm Carriage Bolts (1) up
through the Stabilizer (5). Insert two M8 x
62mm Carriage Bolts up through the Base
(4).
Attach the Base (4) to the Stabilizer (5) with
two M8 x 67mm Bolts (11), two M8 Washers
(8), and two M8 Nylon Locknuts (3).
Do not
tighten the Locknuts yet.
F
R
A
M
E
A
S
S
E
M
B
L
Y
1
Before beginning assembly, carefully read the
following information and instructions:
• Because of its weight and size, the weight sys-
tem should be assembled in the location where it
will be used. Make sure that there is enough
clearance to walk around the weight system as
you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The included grease, and the following tools
(not included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by almost anyone. However, the weight
system has many parts and the assembly
process will take time. By setting aside plenty of
time, assembly will go smoothly.