Woodwarm Stoves 10Kw Plus Installation and operating instructions manual - page 25
25
FIREVIEW DOUBLE STOVES
ADDITIONAL
INSTALLATION AND OPERATING INSTRUCTIONS
HEARTH
The stove must stand on a fireproof hearth which must be at least 127mm thick and constructed of a
non-combustible material. The positioning of the stove and the size of the hearth is governed by Building
Regulations for Class 1 Appliances. These regulations state that the hearth must extend at least 300mm in front
and 150mm to the side of the stove. This can be covered with decorative tiles so long as these are also
non-combustible. There must be no combustible material (i.e. wooden wall panels, skirting boards, beams
etc) within 700mm of the rear of the stove. The area of hearth will need to be correspondingly deeper, with
the stove needing two front extensions of 300 mm.
FIRE BOARD RETAINER BRACKETS
These are the two angled pieces of steel with two holes in each bracket which are fitted onto the
baffle support pins either side of the stove before locating the baffle.
BAFFLE AND FLUE OUTLET
The baffle hangs over the fire board retainer brackets, on the baffle support pins, two on either side of the stove.
The dip in the middle of the baffle should be under the fixed top flue outlet.
DE - ASHING
The double depth stove has two ashpans - one located at either end. The single depth stove only has one ashpan
which can be used from either side of the stove (depending on which way it has been placed into the ashpit).
AIR CONTROLS
The main airwash controls are linked together to allow for equal and even air flow throughout the stove.
FUEL LOADING
When loading fuel be careful to have a fuel bed distributed evenly across the grate of the stove. Bear in mind this
double stove will reach only a semi-cleanburn state if the fire is just at one end of the stove.
GRATE
The double depth stove has a double riddling grate, each grate has to be operated from each respective end of
the stove. The grate in the single depth double can only be operated from one side.
FLAT TOP / CANOPY
Please note that all flat tops and profiled flat tops are welded to the stove body, only low and high canopies can
be removed from the stove to lighten it whilst moving it.
Baffle
Fire Board Retainer
Brackets
Fire Board
Baffle Support Pins
Diagram 16