Woodwarm Stoves 10Kw Plus Installation and operating instructions manual - page 8
8
The airwash cover (9kw & 12kw only) is located along the top rear of the air channel above the main door, its two
pins fitting in the two holes, one at each end of the channel. If it has been dislodged in transit, ensure it is
repositioned.
INSTALLING THE STOVE
Remember to leave sufficient clearance in front of the stove for the hinged ashpit door to open fully. Place
stove on chosen level hearth and remove any packaging materials. The shrink polythene can be used as a
cover for the stove whilst installation is in progress as fire cement will mark the stove paint surface if left. If
needed the canopy of the stove may be removed and placed to one side by lifting upwards. Ensure that the
rope in the channel of the underside of the canopy is not discarded, as this is the seal between the canopy and
the body of the stove.
There is normally a piece of cardboard , for protection, behind the door glass. All other pieces of board in the
stove are the fire boards. Turn the knob and open the main/ fire door then carefully remove it by lifting up and
off its hinge pins (retaining these) and place it safely out of the way. From the front of the stove you can now
remove the operating tool, flue spigot, flue blanking plate, baffle, fire boards, fire board retainer
brackets (two on 9kw and Double stoves only) and the grate bars if necessary.
The ashpit door can be opened, by turning the door handle anti-clockwise. The ashpan can now be removed
and used for holding the grate bars if you need to remove them, which can be done easily by rotating them fully
open then lifting each one out of the grate link bar, outwards and upwards. Underneath the ashpan in the base
body of the stove are the levelling bolts. These bolts can be turned the other way around if necessary or used
for fixing legs or plinth (optional extras) to the stove. The stove can now be levelled by using the levelling bolts or
fixed to the hearth through the bolt holes. Additional brackets are supplied with the 5kw, 7kw and 10kw slim line
stoves. These brackets should be fitted and used to secure the stove to improve stability.
Side Fire Board
Airwash Cover
(9kw & 12kw Only)
Fire Board Retainer
Brackets
Diagram 4
Additional brackets supplied on slim line
stoves only. These should be fitted and
used to provide additional fixing points for
securing the stove (to improve stability).
Diagram 3