Worldlawn WY 36 Operator's Manual - page 13
8
2.6 Operator Controls (See FIG 1)
Key switch: Located on the control panel. Recoil
starter has two positions. Turning to "on" starts
the engine; turning to "off" stops the engine.
Electronic ignition model has three positions.
When starting, turn to "start" position; then
remove your hand.
Throttle Control: Located on the control panel.
Throttle is used to control engine speed. Moving
throttle lever forward will increase engine speed
and moving throttle lever to the rear will
decrease engine speed.
Blade Drive Lever: Push the mower blade drive
lever forward to the engage position. Pull the
mower blade drive lever backward to the
disengage position to stop the blades.
Hand actuated operator presence lever: When in
normal operation, compress the operator
presence lever. When released, engine will kill.
Steering Brake Levers: While squeezing the
steering lever handles with both hands, release
right and left neutral latches; then release right
and left steering levers to move forward. When
the steering levers are released, the mower will
travel straight forward. To make a right turn,
squeeze the RH steering lever. To turn left,
squeeze the LH steering lever. Squeeze both
steering levers, lock right and left neutral latches,
and the mower will stop.
Neutral Latches: Located on bottom of the
handles. They are used to lock the steering brake
levers when stopping.
Gear shift lever: It is used to control the speed.
Foot Pedal: Compress the pedal to the lowest
position; the discharge chute will rotate up,
mulching plate will be closed, and the mower
will be in the mulching mode. Tap the pedal to
the left; the mower will attain its highest position
automatically, the discharge chute will be down,
mulching plate will be open, and the mower will
be in the discharge mode.
Fuel shut-off valve: The fuel shut-off valve is
used to shut off the fuel when the machine will
not be used for a few days, during transport to
and from the jobsite, and when parked inside a
building, see FIG 6.
Blade Drive Lever
Throttle Control Lever
Key Switch
Operator Presence
Lever
Steering lever
Latch, Right
Shift lever
Pedal
Latch, left
Bolt M6×12
FIG 1
FIG 2
2.7 Accessories:
a) Grass catcher assembly (WY36-NGC): 100L, see
FIG 3
b) Mulching Blade and Mulch Baffle (AS36006):
See FIG 4
c) Sulky: See FIG 5
FIG 3