Worldlawn WY 36 Operator's Manual - page 14
9
FIG 4
FIG 5
2.8 Approximate Dimensions:
2.8.1 Width:
Discharge chute down 46.6in (118cm)
Discharge chute up 39.3in (100cm)
2.8.2 Overall Length: 71.6in(182.0cm)
2.8.3 Overall Height: 41.7in (108cm)
2.8.4 Curb Weight: 450lbs(205Kg)
2.9 Torque Requirements
Cutter Housing Spindle Nut: 140-145ft-lb
(190-197N-m)
Blade Mounting Bolt: 115-120ft-lb(156-163N-m)
Engine Deck/Front Frame Mount Bolts:
41-52ft-lb(55-70N-m)
3. ASSEMBLY INSTRUCTIONS
3.1 Open Crate
Open crate. Remove the loose parts (i.e., operator’s
manual, etc) from crate. Remove unit from crate;
check there are no loose parts left.
3.2 Initial Instructions
Attach the handle with four M10×30 Hex Hd
Bolts and four M10 Nuts on each side as show in
FIG 6
Each of the control rods must be connected.
Follow the instructions to properly adjust each of
the controls as shown in FIG 6.
Attach the foot pedal to the console frame with
M6×12 bolt and washer. See FIG 6
Put the fuel tank into the position and lock it as
shown in FIG 6.
The Throttle Cable must be attached to engine
according to the Engine Operator’s Manual. Fuel
Tank line connects to the line of engine. SeeFIG7
Electric, connect connection A to connection B
on the handle bar. Recoil, connect the wiring
harness connection to engine flame-out wiring
harness and neutral switch. See FIG6 and FIG7.
Operator presence lever
Blade drive lever
Key switch
Latch, right
Latch, left
Fuel tank
Clamp
Throttle control lever
Steering lever
Shift lever
Shut-off valve
Bolt M10×30
Swivel&
Hair pin
Steering lever
Cable unit
Bolt M8×25& bolt M8
Swivel, Nut M6
Pedal
Control Rod
Gear switch
Handle bar assembly
Connection B
Connection A
FIG 6
FIG 7