X-Digital System XDS PRO04P Quick Start Manual - Warning!
1327 R830002-1062
XDS PRO4P Quick Start Guide
5/6/2010
Rev A
Page 11 of 11
Important Notice
FCC Compliance
T
HIS DEVICE COMPLIES WITH
P
ART
15
OF THE
FCC
RULES
.
O
PERATION OF THIS DEVICE IS SUBJECT TO THE FOLLOWING TWO CONDITIONS
:
(1)
T
HIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE
;
AND
(2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED
,
INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION
.
UL and CSA Compliance
T
HE
XDS-PRO
DVB
S
ATELLITE
R
ECEIVER WAS TESTED ACCORDING TO
UL
60950-1:2003
AND
CSA
C22.2
N
O
.
60950-1:2003.
T
HIS DEVICE MEETS THE
SAFETY AND TEST REQUIREMENTS OF THE TEST SPECIFICATIONS
,
AND WAS FOUND TO BE IN COMPLIANCE WITH PROTECTION AIMS OF THE APPLICABLE
EC-
DIRECTIVES AND THE REQUIREMENTS OF THE STANDARDS
.
THE
XDS-PRO
DVB
S
ATELLITE
R
ECEIVER MAY BE MARKED WITH THE
TUV
MARK AS SHOWN
BELOW
;
C
ERTIFICATE
N
O
.
U8
07
01
62269
001
Acknowledge of Trademarks
Any product or corporate names used herein may be trademarks or registered trademarks, and are only used for identification
and explanation, without intent to infringe. Any terms mentioned or used that are known trademarks or service marks have
been appropriately capitalized and italicized. X-Digital Systems, Inc. cannot attest to the accuracy of this information. Use of a
term in this document should not be regarded as affecting the validity of any trademark or service mark.
Patent Pending
X-Digital Systems, Inc., DVB Satellite Receiver – Patents Pending
Disclaimer
This document is intended to provide information about the “XDS-PRO4P DVB Satellite Receiver”. Every effort has been made
to make this document as complete and accurate as possible, but no warranty or fitness is implied. The information is provided
on an “as is” basis and X-Digital Systems shall have neither liability nor responsibility to any person or entity with respect to any
loss or damages arising from the information contained in this document.
Warning!
Approved external telecom power cross protection must be incorporated into the final
installation in accordance with Annex NAC of UL/CSA standard 60950-1. Failure to
comply may result in a fire or electric shock hazard and will void regulatory
compliance certification.