X-Digital System XDS PRO04P Quick Start Manual - page 6
1327 R830002-1062
XDS PRO4P Quick Start Guide
5/6/2010
Rev A
Page 6 of 11
the test is successful. You may need to check settings on the receiver or in your
network including any switches, routers or firewalls. The receiver will need to
be able to communicate on TCP port 80 to the internet. Please see the next
section if you need to assign the receiver a static IP address or configure a proxy
server.
4.2.2 Assigning a Static IP Address
Assigning a static IP address to either the LAN or WAN can be done from the
Network Setup section of the front panel. This section allows DHCP to be
toggled, a gateway to be specified, a static IP address to be set for the LAN or
WAN port, or an HTTP proxy server and port to be specified. When specifying IP
addresses, use the Up/Down keys to adjust the numerical values and the
Left/Right keys to move between octets. The SET key will save the specified
address. Once all adjustments are complete, run the TEST NOC again to make
sure the receiver is able to successfully connect to the NOC. Please see
Appendix A for help on navigating through the front panel menus.
4.3 Verify Audio Reception
Once the receiver is locked to the network carrier, you can verify audio functionality as
follows:
4.3.1 Verify Audio Reception
From the factory your receiver is configured to play out the Test Channel for
your network on all audio ports, however, your network may ship the receiver
with current programming and authorizations active. Even if this is the case, the
Test Channel can be used to verify audio reception as well as verify proper
wiring to the rear DB-9 connector.
Connect a set of headphones (or use front panel speaker) and verify you can
hear the Test Channel.
To manually program the XDS receiver speaker/headphone to output the Test
Channel:
At the main screen with the network logo, press the SET key, then
the left or right arrows to reach Audio Ports. Press SET.
Press the left or right arrows to reach Headphones. Press SET.
Press the left or right arrows to reach Program. Press SET.
Use the up and down arrows to find the network’s Test Channel.
Press SET.