X-Digital System XDS PRO04P Quick Start Manual - page 7
1327 R830002-1062
XDS PRO4P Quick Start Guide
5/6/2010
Rev A
Page 7 of 11
4.3.2 Verify Audio Ports
Each DB-9 connector carries one radio program stream, either mono or stereo.
If the program is mono, the same audio appears on the left and right pin pairs.
In most cases, the left and right sides of a stereo channel are no longer used to
carry unrelated mono programs.
To manually program the XDS receiver to output the Test Channel on a desired
audio port:
At the main screen with the network logo, press the SET key, then
the left or right arrows to reach Audio Ports. Press SET.
Press the left or right arrows to select the Audio Port (letter A, B, C
or D). Press SET.
Press the left or right arrows to select Program. Press SET.
Use the up and down arrows to find the Test Channel. Press SET.
Verify that you can hear the Test Channel through all receiver ports.
5 Verification of Programming and Activation
You can edit and activate the programming schedule of your receiver through the Affiliate website
of your network. The URL for this site is provided on the Network Data Sheet.
To login you will use the serial number of your receiver as the username and a password generated
by the receiver. The password can be found as follows:
On the front panel in the Setup section where the serial number is displayed press the 3
soft key to show the daily password.
Use this password along with your receiver serial number to log in to the Affiliate website
5.1 Setup from the Affiliate Website
Once logged in to the Affiliate website, the following adjustments should be made prior to
activation:
1. Set a friendly password: This will be a persistent password that will allow you to log in
to the site without finding the daily password each day
2. Adjust Time Zone: In addition to the proper time zone for your location, please make
sure your daylight savings settings are correct
The Test Channel is intended to check receiver operation; it does NOT indicate that
you can receive regular network programming. You must complete all installation
and activation steps including a fulltime internet connection to receive program
audio. Your PRO4P receiver must ALWAYS be connected to the internet.