X-GLOO 4x4 User Manual - page 17
Tel. +49 (0) 86 41- 69 48 - 60 | www.x-gloo.com | info@x-gloo.com
17
LED LIGHTING KIT
Hanging the LED Lighting Kit in your X-Gloo
Step 1:
It is easiest to install the LED Lighting Kit during the setup
of your X-Gloo, just after inflating three of the four tubes.
Take the long end of webbing connected to the LED light
and loop it above the Tube intersection
(4)
. Connect it to
the buckle on the other side of the light. Tighten the strap
so the LED light is held snugly against the Tubes.
Step 2:
Next, extend the four toggles on the LED lighting mount
and connect them to the loops on the inside of the X-Gloo
Tubes
(5)
.
Step 3:
Tuck the cable underneath the roof so that it follows one
Tube all the way to the ground
(6)
. The fourth Tube can
now be inflated.
Step 4:
The transformer and dimmer controller can be safely stored
on the ground.
Remove the LED Lighting Kit from your X-Gloo using the steps
above in reverse order. Ensure that the LED light does not hit the
ground when deflating your X-Gloo!
4
5
6
For more information, watch our how-to video at:
www.x-gloo.com/en/experience/videos/