Xantech IR-X10 Installation Instructions Manual - page 10
Page 10
Model IR-X10
© 2002 Xantech Corporation.
PROGRAMMING A SCENE
1. Right-Click in the empty space under Scene Module Level to the right of
the Function List Box. A pop-up window should appear with the choices
Add Light/Appliance Scene and Add Shutter Scene.
2. Select the scene for the module being controlled by left-clicking on the
appropriate choice. You should now see confirmation of this choice in
the Scene Module Window. For example, clicking on Add
Light/Appliance Scene will post (A-1) L/A Scene. (A-1) stands for House
Address A, Scene #1.
3. Click and Drag a Module from the Module Name List Box above and
‘drop it’ just below the scene line you just added. Drag and Drop as
many of the X10 modules you wish to control. Refer to Figure 5.
4. Left click on each of the modules in the Scene Module Window, one at a
time and adjust the Scene Module Level via the slide bar at the top of
the window until the desired percentage of brightness is achieved.
5. Repeat step 4 for each module in the scene
6. The Scene is now ready for placement within a macro on the URC-
2P/B.
Figure 5 – Programming a Scene