Xantech IR-X10 Installation Instructions Manual - page 14
Page 14
Model IR-X10
© 2002 Xantech Corporation.
Proceed as follows:
1. Be sure the URC-2P/B (or other applicable Controller) is connected to
the computer (refer to Dragon Drop-IR Software instructions for proper
connection to PC).
2. From the File menu, select Base Unit Transfer (Ctrl+B). A Project Down
Load window appears with the statement "Synching Please Wait", then
"Transmitting Please Wait".
3. A transfer status bar is shown as the transmission of data progresses.
See Figure 7. Also, the Status LED on the URC-2P/B blinks orange and
green until the transfer completes.
4. The newly programmed unit should now operate all the IR-controlled
equipment in your system.
5. Using the same procedure, you may transfer to any number of
additional Controllers.
Figure 7 – Transferring Data to a Real Controller