Xantech XVCE100IR Installation Instructions Manual

Manual is about: Volume Control, Electronic, 100W, IR

Summary of XVCE100IR

  • Page 1

    Installation instructions xvce100ir volume control, electronic, 100w, ir.

  • Page 2: Installation Instructions

    Installation instructions xvce100ir volume control the xvce100ir is a volume control that provides the touch and feel of an electronic device. With a high-value appeal, no mechanical rotating or sliding parts are used in this high-power volume control design. The xvce100ir is rated to 100 watts and ...

  • Page 3

    Installation, notes, and caution you will need at the very least, a 1/8” slotted screwdriver, a ¼” slotted screwdriver, wire cutters and wire strippers. The recommended speaker wire to be used is 16-gauge stranded copper speaker wire. For runs longer than 100 feet, we recommend 14-gauge stranded cop...

  • Page 4: Jumper Settings

    Impedance jumper settings for identical impedance how to use the impedance jumper setting chart: 1) determine the minimum amplifier impedance (typically either 4- or 8-ohm). This information can usually be found next to the speaker outputs located on the receiver or amplifier. If in doubt, consult t...

  • Page 5: Basic Connection

    Basic connection figure 1.

  • Page 6: Xvce100Ir Rj45

    Figure 1 shows the most basic connection. A power supply must be connected to the xvce100ir. The credit card remote (included) can still be used. However, no ir bus is established to control source components. The 781rg power supply should be connected to the xvce100ir volume control as follows. Xvc...

  • Page 7: Ir System Connection

    Ir system connection figure 2.

  • Page 8: Xvce100Ir Rj45

    Figure 2 shows a more advanced connection. In this application, an ir bus is established. Now almost any remote control can be directed at the xvce100ir to control the source components. Xvce100ir rj45 789-44 connecting block pin 6 (white/green) +12vdc pin 8 (brown) ground pin 3 (orange) ir pin 2 (w...

  • Page 9: Other Connections

    Other connections override: allows page/doorbell signals to override the volume setting in the xvce100ir. A high signal will place the xvce100ir into a preset volume level. To preset the volume level, find the desirable volume level with the up and down buttons. Press and hold the mute button. While...

  • Page 10

    Xantech corporation 13100 telfair avenue, 2/f sylmar, ca 91342 installation instructions, xvce100ir © 2007 xantech corporation, document #9801339b this document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from xantech corporati...