Xceed 7LI18VK Instruction Manual - page 10
10
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool’s construction and
design:
•
Damage to the lungs if an effective dust mask is not worn.
•
Damage to hearing if effective ear defenders are not worn
Additional safety rules for the torch
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
•
Use this lamp only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
•
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used with
another battery pack.
This battery-powered torch may only be charged using
the supplied mains adapter unit. The mains adapter unit
may only be operated with a power supply that has an
alternating current of 230V - 240V and a frequency of 50 -
60 Hz. The use of any other mains adapter units or the use
of the plug pack with another type of power supply may lead
to personal and property damage.
•
When using the lamp, do not allow water to enter
the enclosure, so as to prevent short circuiting.
Instructions for charging the battery in this instruction
manual must be followed.
Additional safety rules for oscillating tools
WARNING: Know your oscillating tool. Do not plug the tool
into the power source until you have read and understand
this Instruction Manual. Learn the tool’s applications and
limitations, as well as the specific potential hazards related
to this tool. Following this rule will reduce the risk of electric
shock, fire, or serious injury.
Always wear eye protection. Any power tool can throw foreign
objects into your eyes and cause permanent eye damage.
ALWAYS wear safety goggles (not glasses) that comply with
ANSI safety standard Z87.1. Everyday glasses have only
impact resistant lenses. They ARE NOT safety glasses.
WARNING: Glasses or goggles not in compliance with
ANSI Z87.1 could cause serious injury when they break.
Always keep hands out of the path of the saw blade. Avoid
awkward hand positions where a sudden slip could cause
your hand to move into the path of the saw blade.
Secure workpiece. Use clamps or a vice to hold the
workpiece. It is safer than using your hand and it frees both
hands to operate the tool.
Make sure there are no nails or foreign objects in the part of
the workpiece to be cut or sanded.
To avoid injury from accidental starting, always remove the
plug from the power source before installing or removing an
accessory.
Never use dull blades in the tool. They will cut slower, leave
rough cuts and break easily due to added pressure and
excessive heat. They will also overload the motor and cause
premature failure of the tool.
Never use damaged or bent blades. They will be brittle and
break easily possibly causing injury to the operator.
Never touch a saw blade immediately after using the tool.
The blade will be extremely hot and will burn your hand.
Only use accessories designed for use with this tool.
WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Additional safety rules for Vacuums
•
Do not leave appliance unattended when in use.
Remove the battery when not in use and before servicing
and cleaning.
•
To avoid electric shock, do not expose to rain. Store and
charge battery indoors.