Xceed 7LI18VK Instruction Manual - Rotating Base
23
Rotating Base
The oscillating Tool has a 180° rotatable base.
1. While firmly holding the tool upright with one hand holding
the battery, the tool body can
be rotated either to the left
or right by 90° by using your
other hand to swivel the tool
body.
2. Select the position you wish
to use the tool in before
turning the power on.
On/off switch
1. To turn the tool ON, slide the ON/OFF switch (1) toward
the front of the tool. You will see a “1” on the slide switch
indicating the power is on.
2. To turn the tool OFF, slide the ON/OFF (1) switch toward
the rear of the tool. You will see a “0” on the slide switch
indicating the power is off.
Maintenance
WARNING: When servicing, use only identical replacement
parts. The use of any other part may create a hazard or
cause product damage.
DO NOT use solvents when cleaning plastic parts. Plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use a clean
cloth to remove dirt, dust, oil, grease etc.
WARNING: Do not allow brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. to come into contact
with plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
DO NOT abuse power tools. Abusive practices can damage
the tool and the workpiece.
WARNING: DO NOT attempt to modify tools or create
accessories. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious injury. It will also void the warranty.
Lubrication
All of the bearings in this tool are lubricated with a sufficient
amount of high-grade lubricant for the life of the unit under
normal conditions. Therefore, no further lubrication is
required.