Xceed 7LI18VK Instruction Manual - Switching On And Off
37
Switching on and off
To Start the Vacuum
1. Attach the battery pack
2. Press down the On button
(1) which is marked as
“HIGH/LOW”.
2. This vacuum has 2 speeds,
and will automatically start
in high speed. To change
speed, simply press the (1)
“On/speed button” and the
speed will alter to either
high or low.
3. To turn the vacuum off,
press the Off button (2)
Changing the Vacuum Bag
WARNING. Always ensure that the tool is switched off
before making any adjustments or maintenance procedures.
1. Press the Vacuum bag cover release button (6) to open
the vacuum and access the vacuum dust bag.
2. Whilst holding the vacuum bag support (7) pull the
vacuum bag up out of the unit. The vacuum bag is
located on slide in guides (9) and should come out with
ease.
3. Pull the Vacuum Bag support (7) towards you, and then
push down the vacuum bag cover (8). The cover is now
removed and allows access to empty the vacuum bag.
The vacuum bag (5) can be washed. Make sure the bag
is completely dry before replacing it, and that there is no
clogging of dust within the bag.
NOTE: This vacuum is supplied with 2 vacuum dust bags.
The paper dust bag is used for fine dust. The cloth bag is
used for medium dust.
4. To replace the vacuum bag, re-attach the vacuum bag
cover by first ensuring that the tab on the bottom of the
vacuum bag cover is inserted into the alignment opening
of the vacuum cover.
NOTE: It is important that this is correctly aligned in place
as it seals the vacuum bag from allowing any dust to
escape during use.
WARNING: If this is not fitted correctly, dust will enter the
motor or come out of the vents during operation.
Once this is secure in place, make sure the top of the
vacuum bag support (7) clicks into place over the cover of
the vacuum bag.
Guide the bag and cover, now securely held in position onto
the vacuum bag slide in guides and push the bag down
into place.
5. Close the vacuum bag opening (10) until it clicks
into place.