Xceed 7LI18VK Instruction Manual - Danger
6
•
Only use accessory bits in good condition.
•
Before drilling or driving, check that there is sufficient
clearance for the drill bit under the workpiece.
•
Check where you are drilling or driving. Ensure there
are no hidden electrical cables or pipes where you are
working.
•
Do not touch the bit after operation. It will be very hot.
•
Keep your hands away from under the workpiece.
•
Never use your hands to remove sawdust, chips or waste
close by the bit.
•
Rags, cloths, cord, string and the like should never be left
around the work area.
•
Support the work properly.
•
If you are interrupted when operating the drill, complete
the process and switch off before looking up.
•
Periodically check that all nuts, bolts and other fixings are
properly tightened.
•
When using the drill, use safety equipment including
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful to
the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors. The following hazards may
arise in connection with the tool’s construction and design:
•
Damage to the lungs if an effective dust mask is not worn.
•
Damage to hearing if effective ear defenders are not worn.
Additional safety rules for circular saws
WARNING! The warnings, precautions, and instructions
discussed in this manual cannot cover all possible
conditions and situations that may occur. The operator must
understand that common sense and caution are factors
which cannot be built into this product, but must be supplied
by the operator.
DANGER
a. Keep hands away from cutting area and the blade.
Keep your second hand on auxiliary handle, or motor
housing. If both hands are holding the saw, they cannot
be cut by the blade.
b. Do not reach underneath the workpiece. The guard
cannot protect you from the blade below the workpiece.
c. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
d. Never hold piece being cut in your hands or across
your leg. Secure the workpiece to a stable platform. It is
important to support the work properly to minimize body
exposure, blade binding, or loss of control.
e. Hold power tool by insulated gripping surfaces when
performing an operation where the cutting tool may
contact hidden wiring. Contact with a “live” wire will also
make exposed metal parts of the power tool “live” and
shock the operator.
f. When ripping always use a rip fence or straight edge