Xceltronix i-touch Installation Manual And User's Manual - Instructions
11
it when the INPUT LED remains off. This fingerprint placement process must be
repeated up to five times to ensure an accurate reading. If a fingerprint profile
is accepted, a unique user ID will be generated and the ACCEPT LED will flash
out that user’s ID (Valid IDs are numbered 1-30, where the Master User ID is
always the number 1). If the fingerprint profile is not accepted, the ERROR
LED will flash.
NOTE: Optionally, users can fill in this information to ID /
Fingerprint User table at the back of this manual.
4. If finished with the batch of fingerprint additions, perform i-touch™ / Auto-
closer™ synchronization procedure.
Add A Temporary Fingerprint
(Requires Master User Authorization)
A Temporary Fingerprint is set to expire after a user specified number of days.
To input a temporary fingerprint:
1.
Press the FUNC key, then the 7/TEMPORARY key, followed by the 1/
ADD PRINT key.
2.
Input MF, or MC and the ENTER key. If the MF or MC is accepted, the
ACCEPT LED will flash. If the ACCEPT LED did not flash, it either means
the Master User wasn’t recognized or that the maximum number of finger-
prints have already been added, and the ERROR LED will flash.
3. The INPUT LED should be flashing. The new user should place their fin-
ger on the sensor and remove it when the INPUT LED stops flashing.
This fingerprint placement process must be repeated up to five times to
ensure an accurate reading.
4.
After the fingerprint has been accepted, the INPUT LED should be lit
solid. Enter the number of active days (max 30 days), followed by the EN-
TER key. The temporary fingerprint will expire in the number of active
days (+/- two hours).
5. If the temporary fingerprint addition was successful, the ACCEPT LED will
flash. If the ERROR LED flashes, an incorrect number of days was input.
6. If finished with the batch of fingerprint additions, perform i-touch™ /
Autocloser™ synchronization procedure.
NOTE: Optionally, users can ID their Temporary Fingerprint and
fill in this information to ID / Fingerprint User table at the back of
this manual.