Xceltronix i-touch Installation Manual And User's Manual - Instructions
15
Deleting All Temporary And Permanent Access Codes
(Requires Master User authorization)
1.
Press the FUNC key then the 9/DEL ALL CODES key.
2.
Input MF, or input MC and the ENTER key. If the Master User Authoriza-
tion is successful, the ACCEPT LED will flash, followed by all LEDs flash-
ing.
3. Press the ENTER key to confirm deletion of all access codes. (NOTE:
MC will not be deleted)
4. If all access codes were successfully deleted, the ACCEPT LED will flash.
5. Perform i- touch™ / Autocloser™ synchronization procedure.
NOTE: Master can remove all codes from the table in the back of this
manual.
Door Access Using Temporary or Permanent Fingerprint
1. Be certain the synchronization procedure has been performed since the
last addition/deletion of fingerprints.
2. Properly place finger on sensor until INPUT LED turns off.
3.
If the fingerprint is accepted, then the ACCEPT LED will flash. The garage
door will behave as if the existing garage door opener button were
pressed. If no fingerprint match is found, the ERROR LED will flash.
Note: Sometimes multiple fingerprint reading attempts are necessary
to maintain tight security.
4.
The ENTER key option is now activated and the 10-second timer has
started counting down. (See Tips and Tricks)
Door Access Using Temporary or Permanent Code
1. Be certain the synchronization procedure has been performed since the
last addition/deletion of codes.
2.
Type in an assigned 4-6 digit access code and press the ENTER key.
NOTE: The MC cannot be used for entry/exit purposes.
3.
If the access code is accepted, then the ACCEPT LED will light. The ga-
rage door will behave as if the existing garage door opener button were
pressed. If no code match is found, the ERROR LED will flash.
4.
The ENTER key option is now activated and the 10-second timer has
started counting down. (See Tips and Tricks)