Xelaris XT-6 User Manual - page 6

06

Controls Configuration

A1

E

G

J

L

N

P

V

A

B

C

D

H

I

K

M

O

F

S

T

U

Q

R

I)

Control Stick 

Mode 1: Throttle and Aileron 

Mode 2: Throttle and Rudder

J) Control Stick

Mode 1: Elevator and Rudder

Mode 2: Aileron and Elevator 

K) Trim Switch

L) Trim Switch

M) Trim Switch

N) Trim Switch

O) On/Off Switch

P) Clasp for Shoulder Strap

Q) MENU Key

1) Enter Main Menu

2) Change Menu

R) SUB Key

1) Enter Submenus

2) Change Submenu

S) Y/UP Key

1) Confirm Selection

2) Increase Selected Data

T) RIGHT Key, Next Selection Right

U) N/DOWN Key

1) Cancel Selection

2) Decrease Selected Data

V) LEFT Key, Next Selection Left

W) Handle

X) Bind Button

Y) Simulator Socket

Z) Battery Compartment

A1)Charging Socket

A) Antenna

B) LCD Display 

The following values are shown:

1) Battery Voltage

2) Channel Reversal

3) Duration of Flight

4) Throttle Lock

C) Autorotation Switch

D) Switch for Ch. 5 (Gyro/Landing Gear)

E) Switch for 3D Mode

F) Dual Rate Switch

G) Green Control LED: 

Glows as soon as the transmitter is 

switched on.

H) Red Control LED: 

If the transmitter is switched on in the 3D 

mode and/or the throttle/pitch stick is 

not in its lowest position, the LED will 

glow constantly red. To use the 

transmitter, switch off the 3D mode 

and/or bring the throttle/pitch stick in its 

lowest position. The red LED will then go 

out. 

As soon as the battery voltage drops 

below 8.5 V, the red LED will start to 

blink. 

WARNING: Replace the batteries 

immediately!

X

W

Z

Y

 www.xelaris.ch