Xelaris XT-6 User Manual - page 8
08
3. Miscellaneous Settings
Press the MENU key until you get to the main menu Set.
Go to the four submenus with the SUB key: D‘R, Exp, Ep und Gyr.
3.1 D‘R (Dual Rate)
The Dual Rate function can be enabled for landing approaches.
It reduces the maximal servo deflections to the adjusted value.
1. Choose the desired channel with the LEFT and RIGHT keys
(D‘R1 for aileron/roll; D‘R2 for elevator and D‘R4 for rudder/yaw)
2. Adjust the value with the Y/UP and N/DOWN keys between 0%
and 125%. 100% is the full servo deflection.
3. Save changes according to step 1.2!
3.2 Exp (Expo)
Expo reduces the stick sensitivity around the center point
without limiting the full servo deflection. An agile model can be
(electronically) made smoother and more controllable.
1. Choose the desired channel with the LEFT and RIGHT keys
(Exp 1 for aileron/roll; Exp 2 for elevator; Exp 4 for rudder/yaw).
2. Adjust the value with the Y/UP and N/DOWN keys between
-100% and +100%.
3. Save changes according to step 1.2!
3.3 Ep (Terminal Point)
The maximal deflection of all channels can be electronically
reduced on both sides with the EP function. EP- refers to one
half of the deflection, EP+ to the other one.
1. Choose the desired channel with the LEFT and RIGHT keys.
2. Adjust the value with the Y/UP and N/DOWN keys between
-100% and +100%.
3. Save changes according to step 1.2!
2. Channel Reversal
The direction of every channel can be electronically reversed in the
xelaris XT-6 transmitter. Proceed as follows:
1. Press the MENU key until you get to the main menu Rev.
2. Choose a channel with the LEFT and RIGHT keys and reverse it
with the Y/UP key. You can see on the display which channels
have been reversed.
www.xelaris.ch