Xelaris XT-6 User Manual - page 7
07
Programming
1. Choosing the Model Type
After switching on the transmitter, the main menu is shown. Scroll
through the five main menus (Mode Select, Rev, Set, Cuv, Pls) by
pressing the MENU key several times. Pushing the SUB key allows
you to enter the particular menu.
Every successful keypress is confirmed with a sound. If no sound is
emitted, repeat the keypress. A successful confirmation (Y/UP key)
is followed by two high, consecutive sounds.
1.1 Mode Select / Choosing the Model Type
1. Press the MENU key until you get to the main menu Mode
Select (see ill. on the right).
2. Press the LEFT or RIGHT key to choose the model type (A for 3-
axis airplane; V for V-tail; C helicopter with CCPM swash plate;
H for helicopter with mechanical swash plate mixer; D for delta
model) and confirm with Y/UP. YES means that you have
chosen the model type. The digit shows in which memory bank
you currently are.
1.2 Sav / Saving a Model
The model must be saved after each modification of the
settings! As soon as you load a new model, all settings will
be lost if not saved!
1. Press the SUB key in the main menu Mode Select until you get
to the submenu Save.
2. Choose with the LEFT or RIGHT key the memory bank on which
you want to save the model.
3. Confirm by pressing the Y/UP key. You can save 12 models in
total.
1.3 Load / Loading a Model
1. Press the SUB key in the main menu Mode Select until you get
to the submenu Load.
2. Choose with the LEFT or RIGHT key the model memory you
want to load. The designation refers to the model type
(example: H for helicopter) and the mode (L means Mode 2 and
r means Mode 1). NON means that there are no data in this
model memory.
www.xelaris.ch
If you unintentionally press Y/UP in the menu Mode Select of an existing model, all
data will be overwritten with a completely new model. To recover the data, reload the
model in the menu Load. Switching the transmitter on and off does not recover
the data!