Xerox 6279 Printer User Manual - page 64

6. Select Print Interrupt Timeout

The Print Interrupt Timeout screen displays.

7. Using either the scroll buttons or the numeric keypad, select the desired setting, and

then select Save.

8. Select Save to return to the Control Panel screen.

Calibrate Touch Screen

Your User Interface Touch Screen is calibrated when it is installed. Calibration aligns the

cursor to the place on the screen that you touch. The user interface does not typically

need to be recalibrated, unless it is not working correctly or you reinstall the controller.

1. Press the Services button on the Control Panel.

The Services menu screen displays.

2. Select Machine Info from the Services menu screen.

The Machine Info screen displays.

3. Select the Administration tab.

4. Select Control Panel.

5. Select Calibrate Touch Screen.

6. Press and hold your finger on the calibration symbol in each corner of the screen until

it moves to the next corner. It will touch all four corners.

7. Once the symbol moves to all four corners, the user interface prompts you to touch

anywhere on the screen to save the calibration data.

8. The User Interface saves the calibration data and displays the Control Panel screen.

Network Setup

Prior to being able to communicate with your FreeFlow Accxes scanner and printer, the

FreeFlow Accxes controller needs to be configured to the network.

The Network Setup settings allow the System Administrator to setup the following

TCP/IP settings:

• IP Address

• Gateway

• Submask

• DHCP

If you do not know the above information, perform the following steps to generate a

Configuration Report:

1. Select Machine Info on the Services menu.

2. Select the Print Reports tab.

3. Select Printer Configuration.

Instead of entering the IP Address, Subnet Mask, and Gateway Address, you may

enable Dynamic Host Configuration Protocol (DHCP) on the Network Setup screen.

Xerox

®

 6279

®

 Wide Format Solution

3-20

Printer User Guide

System Administration