Xerox apeosport 350 I Network Administration Manual - page 121
Configuration of the Job Flow
119
Using Scan Servi
c
e
12
Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet
Services.
1
Start a web browser.
2
Enter the machine's IP address or the Internet address to the address entry column on
the browser, and press the
z
Example of the IP address entry
http://192.168.1.1/
z
Example of the Internet address entry
http://xxx.yyyy.zz.vvv/
Note
• When specifying a port number, add “:” and a port number to the end of the Internet address.
3
Click the [Properties] tab.
4
Click [Start Port].
5
Select the [UDP] check box under [SNMP].
6
Reflect the values as the machine's setting values.
1) Click the [Apply New Settings].
2) Enter the System Administrator user ID and password into [User Name] and
[Password], and click [OK].
Note
• The default user ID is “11111” and the default password is “x-admin”.
3) The right frame on the web browser will change to the machine reboot display.
4) Click [Reboot]. The machine will reboot and the setting value will be reflected.
Configuration on the Computer
The following describes the configuration for a computer.
Install CentreWare EasyOperator on the computer.
Refer to the manual contained in the CentreWare Utilities CD-ROM for the installation procedure of
CentreWare EasyOperator.