Xerox Color C75 Press User Manual - page 331
2.
Reinsert the container into the SquareFold Trimmer Module.
3.
Ensure that the container is fully pushed in, and that the indicator light is not lit.
4.
If fault persists, repeat the previous steps.
5.
If fault persists, power off/on the machine.
6.
If fault persists, call for service.
013-941
Cause: The Trimmer Waste Container is full or has a fault
Remedy: Perform the following:
1.
Pull open the container and empty any trimmer scraps from it.
2.
Reinsert the container into the SquareFold Trimmer Module.
3.
Ensure that the container is fully pushed in, and that the indicator light is not lit.
4.
If fault persists, repeat the previous steps.
5.
If fault persists, power off/on the machine.
6.
If fault persists, call for service.
013-943
Cause: Booklet Tray on the SquareFold Trimmer Module is full
Remedy: Perform the following:
1.
Remove any booklets from the tray.
2.
If fault persists, power off/on the machine.
3.
If fault persists, call for service.
Technical data
Specifications
Specifications
Item
• Maximum: 13 x 18 in./330 x 457 mm
• Minimum: 8.5 x 11 in./A4 SEF
Note
The SquareFold Trimmer Module requires both Interface Module and the
Booklet Maker Finisher.
Paper size
• 5-20 sheet booklet (up to 80 imaged sides) at 24 lb./90 gsm
• 5-25 sheet booklet (up to 100 imaged sides) at 200 lb./80 gsm
Cut amount: 2-20 mm, adjustable in 0.1 mm increments
Trim capacity
18-27
Xerox
®
Color C75 Press
User Guide
SquareFold Trimmer Module