Xerox DocuPrint C2255 Quick Referenc Manual - page 91

 Installing the Parallel Port 

91

2.

Unplug the power cord from the power outlet 

and the printer.

3.

Loosen the two screws on the back right side 

of the printer. 

4.

Pull out the handle on the control board and 

then carefully pull the control board out of the 

printer. Place the control board on a table top 

or some other flat surface.

Important

• When pulling out the control board, hold it with both 

hands so you do not drop it.

5.

Remove the two screws on the control board 

and then remove the dummy plate. 

Note

• Note that you will need the screws you remove here in 

step 7 of this procedure.

6.

Aligning the Parallel Port (with frame) with 

the control board connectors, insert the 

Parallel Port from above into the connectors.

7.

Use the screws you removed in step 5 to 

secure the Parallel Port to the front plate of 

the control board.

8.

Reinsert the control board back into the 

printer. Holding its handle, slide the control 

board back into the printer.

Press the control board in as far as it will go.