Xerox Fiery EX2101 Quick Start Manual - page 6
6
Quick Start Guide
Preparing to print
To set up the Fiery EX2101 for printing, you must perform the following tasks:
• Connect the Fiery EX2101 physically to a functioning network.
• Configure the network server.
• Set up the Fiery EX2101 from the Control Panel.
• Prepare client workstations for printing.
A brief explanation of each task follows.
Connecting the Fiery EX2101 to a functioning network
N
OTE
:
When you add the Fiery EX2101 to a network, it is assumed that a network
administrator has already installed a network cabling system and connected the
workstations and servers. For examples of different networks, see the
Guide
.
T
O
CONNECT
THE
F
IERY
EX2101
TO
A
NETWORK
1.
Prepare a network node for the Fiery EX2101.
2.
Route the cable to a location near the copier where the Fiery EX2101 will be installed,
and attach the cable to the network interface of the Fiery EX2101.
For more information, see Chapter 1 of the
3.
Connect the Fiery EX2101 to the copier and print a Test Page.
For detailed instructions, see the
.
T
O
PREPARE
FOR
F
IERY
EX2101
CONFIGURATION
1.
Print a copier Test Page to verify the copier is functioning normally.
2.
Turn off the copier and connect the interface cable from the copier to the
Fiery EX2101.