Summary of Phaser 6120

  • Page 1

    Replacing consumables 76 replacing consumables about toner cartridges your printer uses four toner cartridges: black, yellow, magenta, and cyan. Handle the toner cartridges carefully to avoid spilling toner inside the printer or on yourself. " the toner is nontoxic. If you get toner on your skin, wa...

  • Page 2

    Replacing consumables 77 when replacing a toner cartridge, refer to the following table. For optimum print quality and performance, use only approved xerox toner cartridges for your specific printer type, as listed in the table below. If you open the top cover, you can find your printer type and the...

  • Page 3

    Replacing consumables 78 do not hold, stand or store cartridges on their ends or turn them upside down; the toner inside the cartridges may become caked or unequally distributed. Away from salty air and corrosive gases, such as aerosols..

  • Page 4: Replacing A Toner Cartridge

    Replacing consumables 79 replacing a toner cartridge note: be careful not to spill toner while replacing a toner cartridge. If toner spills, immediately wipe it off with a soft, dry cloth. If toner out action on the quality/toner out action menu is set to stop , the message replace x toner (where " ...

  • Page 5

    Replacing consumables 80 2 pull the lever, and then open the top cover. " if there is paper in the output tray, remove it. Fold up the output tray before opening the top cover. " do not touch the transfer belt. Please wait then, it displays open door and/ replace x toner press key until display read...

  • Page 6: Caution

    Replacing consumables 81 3 open the front cover and check that the toner cartridge to be replaced has rotated to the exchange position. " you can identify the toner cartridge by the color of the handle and by the letter molded into the handle: c (cyan), m (magenta), y (yellow), and k (black). 4 pull...

  • Page 7

    Replacing consumables 82 6 shake the cartridge a few times to distribute the toner. " make sure that the toner roller cover is securely attached before shaking the toner cartridge. 7 remove the cover from the toner roller. " do not touch or scratch the toner roller..

  • Page 8

    Replacing consumables 83 8 align the shaft on each end of the toner cartridge with its holders, and then insert the cartridge. " before inserting the toner cartridge, make sure that the color of the toner cartridge to be installed is the same as the label on the toner cartridge carousel. 9 press dow...

  • Page 9

    Replacing consumables 84 10 close the front cover. 11 carefully close the top cover. " the printer must complete a calibration cycle (less than 2 minutes) after the toner cartridge has been replaced. If you open the top cover before the message ready appears, the printer stops and repeats the calibr...