Xerox WorkCentre C226 Quick Connect Manual
WorkCentre C226
Quick Connect Guide
Purpose:
Refer to this guide to modify the printer network settings at the printer user
interface screens if required. For complete instructions refer to the Customer
documentation for additional information.
Note:
A Network Administrator is required to ensure that the printer is configured
properly. To properly configure the printer, the Network Administrator must
supply a valid IP Address, a Subnet Mask, and a Gateway Address if applicable.
DHCP is enabled by default. For more information in regards to Novell printing
and configuration, please refer to the Customer documentation.
Procedure:
The WorkCentre C226 has been designed to connect to a TCP/IP network with
minimal changes. Connect the printer to the network and review the Network
Settings List. Continue with Steps 2-6 and make changes to the printer port /
network as required for your network infrastructure.
Step 1: Default Printer Settings
Default Port Settings
Parallel Port – Enabled
Netware – Enabled
Port 9100 – Enabled
FTP – Enabled
Internet Service – Enabled
Default
Network
Settings
IP Address DHCP (ON)
Printer Name: XC010228
Workgroup: Workgroup
Step 2: IP Setup
Follow this procedure if you want to make any changes to the port settings. If no
changes are required then please move on to Step 3.
1. Press
Machine Administration button on the Local User Interface Operation Panel.
2.
Press System Administrator Tools button. Enter Password (Default: 00000).
3.
Press Printer Selections.
4.
Press Network Settings.
5.
Press IP Address Settings.
6.
DHCP is default – uncheck DHCP and enter IP information if applicable.
7. Press
OK.
8. Press
Yes to restart after making changes.
9.
Reboot the printer using on/off switch on the left side of machine.
10. If no further changes are required, continue to Step 4 in this guide.