Xerox Xerox 4112 User Manual - page 65
X e r o x 4 11 2 / 4 1 2 7 P o s t S c r i p t U s e r G u i d e
3 -19
3 . W in d o w s N T 4 . 0
Hole Punching
Select the punching position. The holes are made based on the
output orientation of the paper. As a result, the holes may not be
punched correctly depending on the position of the image.
NOTE: Moreover, there are limitations for punching holes on
mixed size output. Hole punching for mixed size output is not
available in the following situations:
•
When a setting other than "1 Up" is selected for "Multiple-Up"
in the "Layout" tab
•
When a setting other than "Off" is selected for "Booklet
Creation" in the "Layout" tab
•
When "Double Print" is set to "On" under "Details" in the
"Detailed Settings" tab
•
When a size other than "A3," "B4," "A4," "B5," "8.5 x 11," "11 x
17," "16K (267 x 194mm) / 8K (267 x 388mm)," and "16K (270
x 195mm) / 8K (270 x 390mm)" is selected
•
When a setting other than "None," "1 Staple (Mixed Sizes)," or
"2 Staples (Mixed Sizes)" is selected for "Stapling" in the
"Paper / Output" tab
Hole Punching - Specify the number of holes to punch. Select
from "Use Printer Settings," "2 Holes," or "4 Holes."
NOTE: If "3 Holes" is selected for "Hole Puncher Setup" on
the "Device Settings" tab, only "Use Printer Settings" will be
available for selection. "Device Settings" tab is displayed on
the print driver screen when "Properties" is selected from the
menu of the printer icon in the "Printers" folder.
Stapling/Hole Punching for
Mixed Size Output
Click this button to display the "Stapling/Hole Punching for Mixed
Size Output" dialog box. You can specify the settings for stapling
or punching for mixed sized documents.
NOTE: There are limitations for stapling mixed size output.
Stapling for mixed size output is not available in the following
situations:
•
When a setting other than "1 Up" is selected for "Multiple-Up"
in the "Layout" tab
•
When a setting other than "Off" is selected for "Print Booklet"
in the "Layout" tab
•
When "Double Print" is set to "On" under "Details" in the
"Detailed Settings" tab