Xiamen Rongta Technology 300 Series User Manual - page 10
Xiamen Rongta Technology Co., Ltd.
www.rongtatech.com
9
Power: 2000mAH rechargeable li-ion battery
Power alarm: battery indicator light will be out and Error indicator light (Red)
will be on when printer will run out of power.
Adapter to recharge: battery can be filled in with 5 hours.
Notice: The battery can’t recharge by using Adapter and USB at the same
time.
A charging time available: Normally, the battery could be used for printing 200
meters or 6 hours. The parameter is only for reference; the capacity of battery would
be decreased after a long time and could not confirm the actual print time.
IV Introduction
4.1 Preparing before usage
4.1.1 Battery Dismounting
1. Pull up the buckle, open battery cover, removal the battery;
2. As shown in the picture, put battery into the battery compartment. Please do
not put the negative and positive poles of battery in wrong way;
3. Then closed the battery cover, so success to install battery.
4.1.2 Paper Roll Installation
Battery
y