Xiamen Rongta Technology 300 Series User Manual - page 14
Xiamen Rongta Technology Co., Ltd.
www.rongtatech.com
13
4. If the encryption type for route is “WEP”, the setting of wifitool should fit
to the route.
5. After connecting printer with computer by virtual serial connection via
USB port and finish all the wifi parameter, please choose the relevant
serial port in wifitool, for example COM8, and set up the default baud rate
of printer as “19200”(if customers set up baud rate through dial switch,
input the right one),then apply it.
4.3.3 Bluetooth Matching and Printing
RPP300 portable printer should match to the primary device of printer, which
initiates matching.
Matching methods as follows:
Switch on power of printer
Primary device search for the external bluetooth device
If there is more than one bluetooth device around, select the printer which is
corresponding to BDA address(refer to the self-test page)
Input password “0000”
Finish the matching
About matching method details, please refer to primary bluetooth function
description.
During matching, RPP300 portable mini printer must be power on.
After matching successfully, other PC still can be matched with the printer, and
each printer can be at most matched with 8 PC, if matched with more than eight PC,
the primary printer matched with PC will be deleted automatically, at this time, if this
printer need the PC to drive it, then it need to be re-matched with PC.
4.3.4 Using Bluetooth Interface to Print
For the PC with virtual bluetooth serial port (such as cell phone using the
SMARTPHONE, POCKET PC, PALM, laptops, etc.), after the success of the
matching, you can send printing data through virtual bluetooth serial port to the
RPP300 portable mini printer for printing. If the PC doesn’t have virtual bluetooth