- DL manuals
- XIEGU
- Transceiver
- X108G
- Operating Instructions Manual
XIEGU X108G Operating Instructions Manual
Summary of X108G
Page 1
Hf transceiver v1.0a outdoor edition revise: 2015-07 copyright © 2015, xiegu, inc. X108g operating manual xiegu tech.
Page 2: Security Considerations:
~ 2 ~ all rights reserved important reminder: before operating the equipment, please read our operating manual carefully and keep the manual, so as not to lose. Security considerations: do not use equipment during a lightning storm. Damp-proof ! Don't illegal operations! Note rf high-voltage of ante...
Page 3
~ 3 ~ 一、machine parameters basic parameters frequency range: receive: 0.5~30mhz(continuous) transmitting: all hf amateur bands including warc bands operating mode: ssb(j3e) cw (a1a) am (a3e) minimum frequency stepping: 1hz antenna impedance: 50Ω operating temperature range: -10℃ ~ +60℃ frequency sta...
Page 4
~ 4 ~ dynamic range: better than 90db rit frequency control range: ±1khz audio output: 0.5w@8Ω 二、 description of equipment 2.1 front panel description 2.2 rear panel description.
Page 5
~ 5 ~ 1. So-239 antenna jack . 2. Aux 3. External speaker output 4. Cw key input. 5. Acc port. 6. Usb port. 7. Dc power input 8. Ground connection. 2.3 microphone 1. Lock button/ press it unlock again 2. Ptt button 3. Up / down frequency/channel 4. Receiving indicator 5. Multifunction 6. Filter sele...
Page 6
~ 6 ~ 【att】switch receive signal attenuator on or off. 【pre】switch receive preamp on or off. 【mode】 select desired operating mode – cw/am/lsb/usb. 【agc】 select agc level – fast/slow/off. 【nb】 select nb level between 1 and 4. 【a/b】 switch between vfo a & vfo b. 【a=b】 set vfo a the same as vfo b. 【spl...
Page 7
~ 7 ~ 【fil】select filter 【key】 select keyer – manual/auto l/auto r. 【kspd】 select keying speed - adjust via selector knob b, speed displayed under key in oled 【time】 set internal clock – adjust via selector knob b, select hour/minute with up/down buttons. 【sql】 select to adjust squelch level via sel...
Page 8
~ 8 ~ 3.2.4: preamplifier on/off press the frequency knob to switch the current menu page, then press [pre]. When the preamplifier is on, pre will be highlighted green. When the preamplifier is off, pre will appear dark. 3.2.5: attenuator on/off press the frequency knob to switch the current menu pa...
Page 9
~ 9 ~ the radio will receive on vfo-a and transmit on vfo-b. 3.2.11: rit tuning press the frequency knob to switch the current menu page, then press [rit]. Turning the frequency knob will change the receive frequency but leave the transmit frequency unchanged. Pressing [rit] again will exit this mod...
Page 10
~ 10 ~ the information stored in the current channel. 3.2.17: manual / automatic telegraph key press the frequency knob to switch the current menu page, then press [key]. Choose manual key, automatic left hand telegraph key or automatic right hand telegraph key. 3.2.18: automatic telegraph key rate ...
Page 11
~ 11 ~ 3.3 extended interface 【aux】no function 【spk】external speaker output speaker or headphone(3.5 stereo socket); otherwise it will damage the rig. Before using the headphone, please decrease the volume. 【keyer】telegraph key the telegraph key is automatic and manual integration. You can switch in...
Page 12
Band voltage parameter 【usb】usb port pc control or firmware update 【dc in】 power port power socket polarity, as shown: note : power input range: 12~14.5v dc do not exceed the input voltage range and reverse access to power 【ground hole】 【ground screw】 3.4.Advanced menu settings caution: these settin...
Page 13
~ 13 ~ to enter menu setting mode: power off radio. Press and hold f1 button while powering on. 1. If ssb: ssb if 2. If cw: cw if 3. Bfo lsb: bfo value lsb mode 4. Bfo usb: bfo value usb mode 5. Bfo cw: bfo value of the cw mode 6. Cw tone: cw side tone pitch frequency adjustment 7. Cw tdly: cw launc...
Page 14
~ 14 ~ after sales service policy our company will promise to purchase the products of the company's, which are the products of the chongqing xiegu technology co., ltd.: period of warranty is 1 year after date of purchase. 1. 0 - 10 days. If a radio arrives at customer's location in not-working cond...
Page 15
~ 15 ~ 无线科技,无限创造 www.Cqxiegu.Com xiegu tech.