XIEGU X5105 Manual - page 17
Xiegu X5105 QRP Transceiver
17
20
CTCSS Tone
CTCSS Tone Frequency
----
88.5 Hz
21
CTCSS (Tx only) Tone –Transmit only
----
Disable
22
Reset ALL
Reset - Factory Parameters No/Yes
No*
*Use
Reset All
only if a software glitch renders the radio unusable or to activate new firmware.
Don’t make any adjustments in the System Menu unless you feel technically competent to do so and
understand what the impact will be on normal operation. If you make gain changes, write down the original
setting first, then introduce new values in small increments. If you find that the FM carrier frequency is off
frequency use an accurate frequency counter and adjust
12
NFM Tx IF setting up or down by the amount of
the error.
60M OPERATION
When operating on the 60 Meter band you have to dial in the correct channel frequencies. It is recommended
that the channels be programmed into memory for convenient retrieval.
USB CW DATA
5330.5
5332.0 MHz
5346.5
5348.0 MHz
5357.0
5358.5 MHz
5371.5
5373.0 MHz
5403.5
5405.0 MHz
REMOTE BAND TRACKING
The X5105 Accessory Port (ACC) provides dc voltage levels to drive remotely controled band-switching
circuitry in RF amplifiers and other devices. The band-tracking voltage appears on the
Band
pin of the
connector (see ACC connector diagram on page-3).
Band
Voltage
Band
Voltage
160-M 230 mV
17-M
1610 mV
80-M
460 mV
15-M
1840 mV
60-M
690 mV
12-M
2070 mV
40-M
920 mV
10-M
2300 mV
30-M
1150 mV
6-M
2530 mV
20-M
1380 mV
------
-----------
DATA COMMUNICATION
You may transmit as well as receive data using PSK-31 and other digital modes by connecting your
computer through a USB Radio Interface such as the MFJ-1204. Refer to the radio’s ACC jack diagram for
pin connections. Be sure to follow all instructions and operating suggestions in your USB interface manual
and operating software.
FIRMWARE UPDATES
[ ] To update your firmware,
do not go to the cqxiegu website
. Instead use the latest firmware download
available at
https://www.mfjenterprises.com/SoftwareDownloads.php
.
[ ] You’ll also need to download the
TeraTerm
freeware terminal emulator program to establish Com-Port