Xilica Audio Design neutrino series Quick Start Manual - page 12
10
13. A Static IP Address for your Computer - Multiple Devices – No DHCP Available:
In this section, we will be navigating through Microsoft Windows to determine your home
networking information as it applies to manually assigning a unique static IP addresses to your
computer.
(a)
The first step is to open the 'Start Menu' and select Control
Panel.
(b)
Click View Network Status and Tasks under the Network and
Internet header as shown at the right.
(c)
Click on Change adapter settings on the left most tab.
(d)
Left-Click on Local Area Connection and click the
Properties button. Select Internet Protocol Version 4
(TCP/IPv4) then click Properties to access the manual
IP settings.
(e)
Set up your IP address to be 192.168.1.X where the X can be any value from 0 – 255 – but
unique from the other devices that you already manually assigned unique IP addresses to.
(f)
Use the following settings for your PC’s unique static address
: IP Address: 192.168.1.X
(Example – IP might be 192.168.1.185 based on my Subnet Mask:
255.255.255.0
unique device addresses above) Gateway: 192.168.1.1
DNS Servers:
192.168.1.1
(g)
If you set up your devices as per step 12 & 13 on Page 9 & 10 above, you will now see them
appear online and connected in Network View in the NeuConsole software.
14.Firmware Upgrade to Processor Device:
Once you have the processor device and the NeuConsole software connected and operational
and before you start work on a DSP design project - make sure your processor has the latest
firmware installed (www.xilica.com
- verify, download latest firmware & save file to your PC).
Note: It is imperative that power is not disrupted during the firmware update process.
•
In Network View – Right click the device and select “Firmware Upgrade” from the menu
and follow the instructions as shown below.
•
As indicated during the firmware upgrade procedure – a firmware upgrade will erase all
saved data on the device. Do a firmware upgrade first or re-transfer/save a saved project
design file to the processor device after the processor firmware upgrade is complete.