Xilica Audio Design neutrino series Quick Start Manual - page 17
15
(b)
The DSP schematic design page has ‘Input’, ‘Output’ and ‘Logic’ DSP modules already
inserted and shown by default.
(c)
Notice that once you’ve opened up the Neutrino DSP module to display the DSP schematic
design page that under the Component Libraries at the left – the list of
System
Components
has been replaced by
DSP Modules
. DSP modules that can be dragged and
dropped into the DSP schematic design page to create your DSP design schematic.
16.NeuConsole Software -
Creating Your DSP Design Schematic:
For this design example, we will create a very simplistic speaker crossover DSP schematic.
(a) Enlarge the opened, grey dotted DSP Schematic design page, move the Input and Output
DSP modules to the left and right and the two logic modules out of the way (since we will
not be using them this time) to create a larger DSP schematic work area – as shown below.
(b) As shown below - under
DSP Modules
on the left - drag and drop a Matrix Mixer onto the
schematic design work area. (Click on the grey dotted DSP schematic design page to open
the Components Library and the list of DSP modules if it is temporarily hidden).
(c) The Matrix Mixer as dropped/placed in the schematic design area arrives as a 1x1 I/O Matrix
Mixer. As shown above, I have already re-sized the Matirx Input from 1 to 4 inputs for our
design example.
(d) To Re-Size the Matrix Mixer I/O (or any module), click it so it is highlighted in Orange (if not
already highlighted) and see the Input/Output section of the Component Properties menu on
the right. As indicated with the Blue dropdown selection above on Pg 15 & below, I have
chosen to re-size the output side of the Matrix Mixer to 4 outputs – creating a 4x4 Matrix Mixer
(as shown below).
(e) Next, from
DSP Modules
on the left, drag and drop a High Pass Filter (6-24 db/Oct); a Low
Pass Filter (6-24 db/Oct); and a Peak Limiter onto the grey dotted, schematic design area and
re-size each as we did with the Matrix Mixer – as 2x2 Filters and a 4x4 Peak Limiter.