Xilica Audio Design neutrino series Quick Start Manual - page 23
21
project file – thus protecting the original project file. Then continue working
.
Be careful here not to write over a saved project file by mistake.
(e)Note the green “Mute All Devices” speaker symbol button at the top of the Online Mode
page to the right of the System Presets button.
19.Working Offline:
Of course you can work on a DSP design project and save it to a file while “Offline” - no
network interface detected / no processor connected, no Map Physical Device action taken, and
without transferring / saving your work to the processor device right away. Then later, connect
processor, Map Physical Device, open your saved project, and transfer/save your saved DSP
design project file to the connected processor device by selecting the “Switch to Online Mode”
button.
20.Open Design Project:
Open Design Project or Open Project is where we open or access previously worked on and
saved DSP design project files - as compared to creating a New Design Project as we did above.
•
From the software NeuConsole
Startup window – Select “Open Design Project” and select
and open the specific DSP design project saved in your PC (.pjxml files).
•
Or - From the Network View or Project View window - Go to “File” at the top of the page,
select “Open Project” and select and open the specific DSP design project saved in your
files.
•
In both cases the saved DSP design project once opened will appear in your Project View/
Design Mode work area. Double click the red processor module in the work area to view
the saved DSP design project schematic. Double click DSP modules to open them and
make parameter adjustments as required.
•
Save your work as you go and the balance of your work operations are the same as
described above in New Design Project.
21.Open Device:
(Quick Access to a Programmed Processor Device)
If you are connecting to a processor device that has already been programmed with a DSP
design project and you need quick access to the processors DSP to check out its settings or to
make new “Live” DSP module parameter adjustments,
(a) Connect to the processor device.
(b) Open the NeuConsole software.
(c) From the NeuConsole Startup window select Start “Network
View”.