Xpand X103-CP User Manual - Handling Instructions

© XPAND, All Rights Reserved. 

7 

www.xpand.me

Both lenses should flicker at a visible rate and in doing so indicate that the glasses 

are functioning properly and are ready for distribution. If the lenses do not flicker, the 

battery is empty and should be replaced before further use. 

Handling Instructions

Replacing the Battery

Battery is located inside the glasses on their right side and is covered with a plastic 

cover. 

The plastic cover can only be opened with a special tool (screwdriver), as shown in 

the drawings below. Opening it without the tool is extremely difficult which makes it 

hard for the user to open it and remove the battery.

Unlike their predecessor (the X101 glasses) the battery in XPAND Pi Cinema 3D 

Glasses is not encapsulated in a plastic case which acted as a sealing cover in 

X101s. Because of that XPAND Pi Cinema 3D Glasses are 

not designed to be washed 

in the dishwasher.  

Follow below steps to open the battery compartment in your Pi Cinema 3D Glasses 

and replace the battery. 

Step 1 Insert the tool into the opening of the battery case, located on the right side 

of the glasses

.

Step 2 Use the inserted tool as a lever – while inserted in the opening of the battery 

case, gently push it downwards.