Xpresskit CANMAX400 Installation Manual - Remote
Rev.: 20101015
Platform: CANMAX400
Firmware: GM10
© 2010 Directed Electronics. All rights reserved.
Vehicle Canbus Integration System
Wiring Diagram
Page 3
XK-400X
1:Black: (-) Ground
2:Red: (+) 12V
8:Blue: (-) Unlock Input
9:Green: (-) Lock Input
10:Violet: (+) Starter Input
12:Blue/White: (-) GWR (Status)
11:Pink: (+) Ignition Input
1: (+) 12V
TX
1:(AC) Tach Output*
(AC) Tach Input
2: RX
(-) Ground
2:(-) Door Status Output
(-) Trunk Status Input
(-) Hood Status Input
3: (-) Ground
RX
3:(-) Trunk Status Output
4:(-) Hood Status Output
(-) Door Status Input
4: TX
(+) 12 V
Need to use one key.
19:Yellow: RF Loop
Pin 15
Pin 5
Pin 6
18:Brown: RF Loop
6: Green/Black: RAP Off***
5: Black/White: (-) Handbrake Output**
Ignition
15: Red/White: Accessory
11:Green: SW CAN
9: Purple: Multiplex Output
10: Purple/Brown: Multiplex Output
Programming Button
Remote
Starter
12
4
20
4
Parking Lights
Horn
(-) Handbrake Input**
(-) Ground
(+) 12 V
(-) Unlock Output
(-) Lock Output
(+) Starter Output
(-) GWR (Status)
5-6 loops around
ignition switch
5-6 loops around
ignition keyfob
BCM
under driver side
of dash
D1: Diagnostic
connector OBDII
(wire side view)
1
8
16
9
Connect to driver
door sense trigger
(Gray/Black wire)***
* See features #2 to activate/deactivate Tach Output. The Tach wire is an optional connection required on some remote starters not supporting tach
signal in D2D.
Not required in D2D mode.
*** If the RAP OFF wire is not connected, only the radio will turn OFF but some lights will remain ON inside the vehicle. Connect this wire (Green/Black,
pin 6) to avoid the issue.
** Handbrake Output wire is only connected if the vehicle is equipped with a manual transmision.