Xpresskit CANMAX400 Installation Manual - page 6
Rev.: 20101015
Platform: CANMAX400
Firmware: GM10
© 2010 Directed Electronics. All rights reserved.
Vehicle Canbus Integration System
LED
Status
Description
Troubleshooting
Programming the Module
Solid green x3
seconds
Module has been successfully
programmed.
Normal operation.
Remote Starting the Vehicle
Flashes green
Module is operating correctly.
Normal operation.
Off
N/A
The Ground While Running (status) wire is incorrectly
connected. Refer to the wiring diagram to make the right
connections.
While the Ignition is Turned Off
Flashes green x1
Lock feature.
This can also mean there is an issue with the wiring. Refer
to the wiring diagram to make the right connections.
Flashes green x2
Unlock feature.
This can also mean there is an issue with the wiring. Refer
to the wiring diagram to make the right connections.
Off
Module has no power.
Make sure the D2D harness is connected or that the 12
Volt is present between the red and black wires. If the 12
Volt is present, the module may be defective.
Page 6
1
2
3
Press and hold the Programming button, then power the module:
- D2D: connect the D2D cable; or,
- W2W: connect the 12-pin harness.
When the LED turns ON orange, release the Programming button.
The module reset is complete.
&
&
Connect the 20-pin harness.
Resetting the Module
Solid Orange
Solid Red
LED Diagnostics
(
)
(
)
20-pin
x3
secs
(
)
(
)
x1
(
)
(
)
x2